Hey gang. I fired up both my Weber Smokey Performer and the WSCGC today to smoke four racks of St. Louis cut spares. At first I was going to season all four racks exactly the same but made three the same and then the one spicy.
I loaded five scoops of Royal Oak standard briquettes in each and ran the gas assist on both for about seven and a half minutes. They came up to close to the same temps in about the same amount of time. It was also to maintain them at about the same temps. The WSP took more vent fiddling and the WSGC was more set and forget. I have an iGrill with two ambient probes that i was watching. No temp controllers on either cooker.
Inside the PSM, I used the GBS grate in its standard position. I pulled out the center grate and replaced it with the big cast GBS wok that i also have. I wrapped that in foil and it worked well. I used a Weber stainless 22 grate for the meat and I rested it on the lower bolts, which is a little higher than the normal lower position.
Here is a look at the ribs after the third spritzer at about 4.5 hours.
This is what they look like after the candy sauce. The one on the right came to temp earlier than the others so I pulled it first. It was also the lightest of the bunch.
And the candied up spicy rack...
And the other two non-spicy ribs are done (they weighted exactly the same).
And lastly, the spicy rack that was on the WSP. It was also the heaviest rack.
The recipe that I used for the non spicy ribs was the same thing that I posted here the other day:
http://weberkettleclub.com/forums/grilling-bbqing/diy-texas-rib-candy-and-killer-hogs-the-bbq-rub/The spicy recipe was teh same as above with some ground up piri piri peppers that I added to the rub. And then to the rib candy, I added a couple of teaspoons of cayenne pepper powder.