..:: UPDATE ::..
I finally made some significant progress on this restore and figured it was time to share some more pics. Recently I have been experimenting with JB Weld High Heat Epoxy putty and it seems that it might offer a good solution for plugging
small holes in and around the common leg socket trouble areas. Essentially you cut a piece off, squish it all together and mix until it turns a uniform grey, then it can be worked with the same consistency as a hard clay. A tiny spray of water on your finger tips allows you to press and mold it into position better which worked out great. Holes are patched and the kettle can now stand (rather securely!) on her own 3 feet. This stuff hardens rock hard so I plan to go back and Dremel down the epoxy smooth on the inside of the bowl once it has a few more days to cure.
Getting the old lower vent rivets out was a pain in the ass but they all came out clean eventually...
Here is the trick we talked about before using a heavy hose clamp to tighten the socket around the leg.
Donor vents all cleaned up and ready to go.
Here's another trick I've used before - trim the square collar off a SS carriage bolt so that it will sit flush against the vent.
Use a simple nut and washer on the inside to help secure the new vents.
Muuuch better
A nice new handle and she's back in the game!!
Another huge thank you to
@fedex - This was a really fun project and I'm thrilled to have an 18 cado as part of the team [emoji106]
Take care guys!
Matt