Welcome, Guest

Shop Amazon.com and support the WKC | WKC T-Shirts

Author Topic: Welp , here I go.  (Read 686 times)

wildeagle

  • WKC Brave
  • Posts: 284
Welp , here I go.
« on: February 09, 2020, 09:09:40 AM »
I hope this turns . I know there is a vid somewhere. Let's see if I can slip the old rubber off without destroying
Ryan  Andrew Moore

Kneab

  • WKC Performer
  • Posts: 3460
Re: Welp , here I go.
« Reply #1 on: February 09, 2020, 09:17:26 AM »
Leave the rubber on. Evapo-rust will not hurt it. Mask and repaint after rinsing.


Sent from my SM-G960U using Tapatalk

ISO Brown Go Anywhere

michaelmilitello

  • WKC Performer
  • Posts: 3802
Re: Welp , here I go.
« Reply #2 on: February 09, 2020, 05:02:23 PM »
Let it soak a good day or so.  Works well in a 5 gallon bucket preferably at 70 Degrees.   

If you’re lucky you might not have to repaint.  I had rust as bad as yours and uncovered this.   In my case, I liked the patina rather than fresh paint. 



Sent from my iPhone using Tapatalk

Kneab

  • WKC Performer
  • Posts: 3460
Re: Welp , here I go.
« Reply #3 on: February 09, 2020, 05:08:25 PM »
I had a few with that same patina and locked it in with some semi gloss clear lacquer.

Sent from my SM-G960U using Tapatalk

ISO Brown Go Anywhere

Mike in Roseville

  • WKC Performer
  • Posts: 2261
Re: Welp , here I go.
« Reply #4 on: February 10, 2020, 05:18:02 AM »
Use Evaporust and don’t remove the tread.


Sent from my iPhone using Weber Kettle Club

Troy

  • Statesman
  • Posts: 9479
Re: Welp , here I go.
« Reply #5 on: February 10, 2020, 06:13:46 AM »
Oh man I really hope he read some replies before removing the tread