I have a Weber Performer and I just ordered a BBQ Guru CyberQ Wifi, so I'll need to drill a hole to install the Pit Viper fan. If anyone has done this, where did you put the whole.
The propane burner is on the right side of the kettle, so I assume the left side is better. It'll be easier to access from the front than it would be from the back, so I'm thinking the front left area would be best. If I put the hole for the fan too low, it would be too close to where the coals are (and aiming upward) and could blow ash around. The lid holder is also on the left side and I don't want it to hit the fan when I put the lid in the lid holder.
I'm just trying to think of all pros/cons because I only want to make one hole.
I appreciate any advice that you guys have.