Best way I’ve found is to use a soft mallet in them and gently beat the shit out them until they conform...Sent from my iPhone using Tapatalk
Quote from: Travis on May 21, 2018, 03:00:41 PMBest way I’ve found is to use a soft mallet in them and gently beat the shit out them until they conform...Sent from my iPhone using Tapatalk+1 this works like a charm [emoji6]Keep your hand on the opposite edge from where you are hammering, holding vent tight to the bowl.
I’m also in need of this information. Is it easy to drill the rivets out and install new vents? If I bought a set of newer replacement vents will they work?Sent from my iPhone using Tapatalk
Quote from: kettlebb on May 21, 2018, 06:03:25 PMI’m also in need of this information. Is it easy to drill the rivets out and install new vents? If I bought a set of newer replacement vents will they work?Sent from my iPhone using TapatalkI considered that but I want to keep the small, single tab vents. The replacements are like 22 WSM vents. Sent from my iPhone using Tapatalk