Welcome, Guest

Shop Amazon.com and support the WKC | WKC T-Shirts

Author Topic: Location of white wire on Performer with assist, pre 2013  (Read 199 times)

Talus

  • Smokey Joe
  • Posts: 35
Location of white wire on Performer with assist, pre 2013
« on: October 08, 2021, 09:59:34 AM »
So I was trying to get my gas assist to work, and pulled the white wire off by mistake.  It broke off with the connector and I can't figure out where it attaches.  I'm talking about the burner tube end, not the end by the regulator.  A picture would be super helpful.  I can't seem to find an exploded view on Weber's site that shows it well.  Thanks!

Easy

  • WKC Brave
  • Posts: 408
Re: Location of white wire on Performer with assist, pre 2013
« Reply #1 on: October 08, 2021, 02:40:10 PM »
Call weber crs for help. Another way is to go to say Ace hardware, a box store and look at the gas tube and wiring locations use your phone and take some photos.


Sent from my SM-G991U using Weber Kettle Club mobile app


michaelmilitello

  • WKC Performer
  • Posts: 3918
Re: Location of white wire on Performer with assist, pre 2013
« Reply #2 on: October 08, 2021, 03:07:13 PM »




Sent from my iPhone using Tapatalk


reynolmm

  • Smokey Joe
  • Posts: 17
Re: Location of white wire on Performer with assist, pre 2013
« Reply #4 on: October 08, 2021, 07:51:05 PM »
The white wire connects to the screw mount that holds the ignitor to the burner tube.


Sent from my iPhone using Weber Kettle Club

pbe gummi bear

  • WKC Mod
  • Posts: 9059
Re: Location of white wire on Performer with assist, pre 2013
« Reply #5 on: October 09, 2021, 10:35:21 AM »
The white wire connects to the screw mount that holds the ignitor to the burner tube.


Sent from my iPhone using Weber Kettle Club

I wouldn’t bother replacing that wire. I’d just strip the end and slip it between the burner tube/screw/ igniter tab.
"Have you hugged your Weber today?"
Check out WKC on Facebook:
https://www.facebook.com/pages/Weber-Kettle-Club/521728011229791