Author Topic: Handle question (Read 2043 times)

Jtayres · « **on:** April 15, 2020, 03:29:52 AM »

Anyone know what size the nut is that holds the taco handles on? I had one of those cheesy looking nuts burn out on me after a mishap with a pre-glazed ham... hoping to replace with stainless instead of buying a whole handle assembly.

The ham was salvageable but not the best.

Sent from my iPhone using Tapatalk

JEBIV · « **Reply #1 on:** April 15, 2020, 03:50:13 AM »

1/4-20 i believe

brewtownbeatdown · « **Reply #2 on:** April 15, 2020, 05:30:21 AM »

Quote from: JEBIV on April 15, 2020, 03:50:13 AM

1/4-20 i believe

I do believe it’s 1/4-20 as well. I’d recommend using an “all metal locknut”. They work the best when you need just the right amount of tension.

Sent from my iPhone using Tapatalk

JEBIV · « **Reply #3 on:** April 15, 2020, 05:48:34 AM »

Quote from: brewtownbeatdown on April 15, 2020, 05:30:21 AM

Quote from: JEBIV on April 15, 2020, 03:50:13 AM
1/4-20 i believe
I do believe it’s 1/4-20 as well. I’d recommend using an “all metal locknut”. They work the best when you need just the right amount of tension.

Sent from my iPhone using Tapatalk

usually listed as prevailing torque locknut when you go to search

Jtayres · « **Reply #4 on:** April 21, 2020, 03:09:45 PM »

Perfect!
Thanks all for the reply’s

Sent from my iPhone using Tapatalk

Author Topic: Handle question (Read 2043 times)

Jtayres

Handle question

JEBIV

Re: Handle question

brewtownbeatdown

Re: Handle question

JEBIV

Re: Handle question

Jtayres

Handle question