They said they think it's a WSM here's the vent???

Started by Red_5_Wrangler, May 07, 2019, 04:45:49 PM

Previous topic - Next topic

Red_5_Wrangler

My old WSM has the ridges on the vent and no little tabs in the holes. Anyone know if this is a Weber vent and if that line on it is a I or L or neither.
ISO - CMist Go Anywhere, the cheif, yellow

HoosierKettle


bladz

I don't think it's any stamp.  It does look like a Weber bottom vent though. 


Sent from my iPhone using Weber Kettle Club

PotsieWeber

The knob on the door looks like the first version of the door knob/latch.
regards,
Hal

Red_5_Wrangler

Quote from: HoosierKettle on May 07, 2019, 04:56:05 PM
I'm calling that a Weber. Go get it.


Sent from my iPhone using Weber Kettle Club mobile app

He has a WSM and says it is really similar but only has one. Shelf. I can't see the tabs for another shelf. It's not near me so I will see if he takes paypal and we will let the gods decide.
ISO - CMist Go Anywhere, the cheif, yellow

PotsieWeber

Most of the cheapie ones I've seen had bolt on handles, not welded on like in the picture.
regards,
Hal

Red_5_Wrangler

Yea I think it is a Weber, it just really through me when he said he has one and he doesn't think it's a real Weber. We will see, he seems to be working with me.
ISO - CMist Go Anywhere, the cheif, yellow

Mike in Roseville

Looks like a Weber to me as well. Although...that grate in the middle is hinged so not original. From what I know, there was a period from the mid-late 1980's to the early-mid 1990's where they weren't stamped.


Sent from my iPhone using Weber Kettle Club

LiquidOcelot

The 18 i had was a 2000s model and there was no way a hinged grate would fit on the middle since it was a smaller diameter

Sent from my SAMSUNG-SM-G928A using Weber Kettle Club mobile app


Mike in Roseville

#9
Quote from: LiquidOcelot on May 07, 2019, 07:55:10 PM
The 18 i had was a 2000s model and there was no way a hinged grate would fit on the middle since it was a smaller diameter

Sent from my SAMSUNG-SM-G928A using Weber Kettle Club mobile app

Agreed. But closer examination of that hinged grate looks like it's sitting in there at slight angle (not on the straps). Then again...where is the top tab of the strap where the upper grate is supposed to sit?

PotsieWeber

#10
A normal sized 18 grate will fit fine in the 18" WSM, but will wind up resting on the nuts, that are slightly above the lower grate supports and that attach the strap to the middle section.  I know, because I bought one like that.
regards,
Hal

Walchit

Did he say he would take PayPal? If not I was about to go grab this one

PotsieWeber

@Red_5_Wrangler said the guy seemed to be working with him.  You might want to message him & see if it fell through or he backed off.
regards,
Hal

Red_5_Wrangler

Quote from: Walchit on May 08, 2019, 11:50:49 PM
Did he say he would take PayPal? If not I was about to go grab this one

He said no to PayPal and I already asked my local friends for too much so I made peace with letting this one go.
Side note, I am also convinced this is an 18 with the center upside down and one missing grate. He said there is no water pan but I think it's there it's just the old smaller one not like the huge ones. Last person I got one from was using it under the charcoal. I hope it's awesome.
ISO - CMist Go Anywhere, the cheif, yellow

Walchit