Good call, buckie! Upon closer inspection, there's a small metal clip, or guard, that would protect the bowl from the (hot) lid. Also, there is a bit of what looks like melted roller drip on the bowl, near where the roller attaches.
My mission is clear: put the bale from the black Plat., which is missing the appropriate lid anyway, on the maroon one and sell the black one bale-less and w/ a reg. lid.
(Sell 1, buy 2).
Thanks.
Finally got around to making the switch and found out, much to my delight, that it's real easy to remove the bowls- 2 nuts inside the bowl and lift out. The tables on the blackie's frame were nicer (cleaner w/ a more attractive to me speckled finish) than the maroon's so I swapped frames, too.
Why was this model so short-lived? Bad price-point? Ugly thermoset tables? Centered lid vent?
I would guess it's because of the bad margins to produce them. Many of the parts were exclusive to the OTP, from the lid, bowl, frame, table, handle, etc etc. at the retail level the price point is well into the entry level gas grill range so I bet it didn't sell well. I would also bet that the timing to sell a midrange premium grill in the 2010 recession was a contributing factor.
This grill was not a Weber designed product. It was contracted out to CHOi Design in Chicago. They've done some excellent work on the higher end product lines like Weber Style Accessories, Summit, 2005 Performer (I think). The charcoal grill market is very cost focused and I bet the the OTP was an experimental grill for Weber. Maybe the idea was to make it more competitive to a Kamado? The two side tables are vey kamado-esque