Welcome, Guest

Shop Amazon.com and support the WKC | WKC T-Shirts

Author Topic: Table build Stainless Steel  (Read 1998 times)

dirtfishingman

  • WKC Brave
  • Posts: 286
Table build Stainless Steel
« on: March 25, 2019, 09:39:55 PM »
Hey guys
I got stain steel table and would like to keep the prep area.  Looking to hang my 22 off the side any ideas?


Sent from my iPhone using Weber Kettle Club

jacko1962

  • WKC Brave
  • Posts: 150
Re: Table build Stainless Steel
« Reply #1 on: March 28, 2019, 10:07:43 AM »
If I were to do it , I would remove the storage area and drop it dead center. I would frame around the underneath and build some nice storage units.
Weber Genesis 1000 Black with all red oak, 1992 Redhead Performer.  2014 18.5 black. 1985 Black GA

Looking for P code Red Premium Master touch and a EO code Blue Premium Master touch .

Jtayres

  • WKC Brave
  • Posts: 181
Re: Table build Stainless Steel
« Reply #2 on: August 27, 2019, 05:35:43 AM »
Did this get done? I think I would trace the circle bit from a ssp in the left side. Probably enough space to keep the drawer and a nice big table to the right


Sent from my iPhone using Tapatalk
Kettles: 2015 Performer Deluxe (Green), 2001 One Touch Platinum, 1999 Performer gas assist, 1991 Smokey Joe Gold (Green) Gasser: Genesis Silver B

Shoestringshop

  • WKC Performer
  • Posts: 2637
Re: Table build Stainless Steel
« Reply #3 on: September 01, 2019, 03:52:05 AM »
If I were to do it , I would remove the storage area and drop it dead center. I would frame around the underneath and build some nice storage units.

Any update?
Wife said "No more GRILLS in this house!" So I bought a 2nd house!