Welcome, Guest

Shop Amazon.com and support the WKC | WKC T-Shirts

Author Topic: Wheel Spacers  (Read 1331 times)

Winz

  • WKC Ranger
  • Posts: 1714
Wheel Spacers
« on: July 24, 2014, 06:21:52 AM »
I have done a few wheel conversions lately.  Typically the aftermarket wheel hubs are 1/2 inch, and the kettle triangle (or performer axle) is 3/8 inch.  To convert, you need a metal spacer (shown below).  While these are not too hard to find, I have 3 extra sets of spacers that I will send to WKC members, first come first serve.  I prefer to send one set per person so 3 members can benefit.  PM me if interested.

Winz









In an ongoing relationship with a kettle named Bisbee.

Heyjude

  • WKC Performer
  • Posts: 4660
Re: Wheel Spacers
« Reply #1 on: July 24, 2014, 06:27:42 AM »
Thats a great offer!    Where did you find these spacers at? AJ  8)
I don't care if you don't like my Avatar, its there for me..

Winz

  • WKC Ranger
  • Posts: 1714
Re: Wheel Spacers
« Reply #2 on: July 24, 2014, 06:29:37 AM »
Thats a great offer!    Where did you find these spacers at? AJ  8)

I have had some luck at the local hardware store, but lately I have been using http://www.aluminumspacers.com

Great service and an unmatched selection.

Winz
In an ongoing relationship with a kettle named Bisbee.

CurtP

  • WKC Brave
  • Posts: 121
Re: Wheel Spacers
« Reply #3 on: July 24, 2014, 06:35:13 AM »
Those aren't aluminum, are they?

McMaster Carr is a good place to get them too.