News:

SMF - Just Installed!

Main Menu

lid reshaped

Started by mtgb, July 01, 2024, 08:32:29 AM

Previous topic - Next topic

mtgb

Anyone have a good way to reshape the lid? this is for a 1986 22" kettle. What about adding a gasket seal or something similar around the rim? I would like to be able to use it for low and slow cooks.

1spacemanspiff

If it's out of round, give it a little hug.  Rinse and repeat until you're happy with the results after test fitting.

ISO Yellow Offset SJ, Yellow ranger

michaelmilitello

#2
+1 on the hugging of a lid.   Definitely helps.   Office binder clips work wonders for low and slow cooks.  Two on opposite sides as circled below.   It will also help shut down/ extinguish coals easier. 




Sent from my iPhone using Tapatalk

Gringo

On gasket I have used Lavalock both high heat silicon pack or just the lavalock self adhesive. Very easy


Sent from my iPhone using Weber Kettle Club