Adjustable side table project

[Transit98]

Thanks to member @DynaGlide I got a Performer side table in the mail last weekend. Unfortunately USPS cracked the side but that was quickly forgiven when the legs part of the project fell into my lap. A neighbor was throwing out an old Electric Keyboard holder on casters that will make for a great set of legs and adjustable height. So I can use this on my 22.5 and UDS.

I want to mount wood onto the center pipe and than mount the table on the wood.

Thanks again to @DynaGlide for offering this up to the forum! 


Sent from my iPhone using Weber Kettle Club

[addicted-to-smoke]

That's a neat idea.

[JEBIV]

very cool idea

[bluewhisper]

Hmmmm, you just gave me an idea for a new use of this crappy office chair I'm sitting on. The seat is getting ripped up but the wheels are still good.

[Transit98]

Hmmmm, you just gave me an idea for a new use of this crappy office chair I'm sitting on. The seat is getting ripped up but the wheels are still good.

make it happen brother! I was in the garage last night working on the best way to security mount the table to the base. Thinking of making a wood frame to hold the table on the sides, as it would in its original table design.

Ill post progress next week.


Sent from my iPhone using Weber Kettle Club

[bluewhisper]

I noticed my Home Depot had some remnants of cut plywood. I figure I can use the 22 lid as a stencil and draw a cutting guide for a curve to match the kettle.

[Transit98]

I noticed my Home Depot had some remnants of cut plywood. I figure I can use the 22 lid as a stencil and draw a cutting guide for a curve to match the kettle.

I can send you the table measurements later tonight or tomorrow. Tip to tip and depth of internal arc.


Sent from my iPhone using Weber Kettle Club

[Firemunkee]

Looking forward to seeing all of these projects