Welcome, Guest
Login or Register

Shop Amazon.com and support the WKC | WKC T-Shirts
« previous next »
Pages: 1 [2]

Author Topic: Adding an Ash Pan to my kettle  (Read 4455 times)

MacEggs

  • WKC Performer
  • Posts: 3477
Re: Adding an Ash Pan to my kettle
« Reply #15 on: September 21, 2013, 09:44:04 AM »
Quote from: cbpeck on September 21, 2013, 09:19:55 AM
Thanks for posting that up, boys! This retrofit has held up well, and I would do it again. Although I will say that I wish I had done a little bit better job of aligning the ash ring with the bottom of the bowl. The fit is really close, but not quite as high & tight as I'd like it.

Glad to hear it's holding up. I noticed the fit earlier ... but, didn't want to say anything ..  ;)
I am considering drilling thru the leg socket. Still haven't decided yet.  ??? ??? :)
Logged
Q: How do you know something is bull$h!t?
A: When you are not allowed to question it.

G$

  • WKC Performer
  • Posts: 3268
Re: Adding an Ash Pan to my kettle
« Reply #16 on: September 21, 2013, 10:12:41 AM »
Quote from: cbpeck on September 21, 2013, 09:19:55 AM
Thanks for posting that up, boys! This retrofit has held up well, and I would do it again. Although I will say that I wish I had done a little bit better job of aligning the ash ring with the bottom of the bowl. The fit is really close, but not quite as high & tight as I'd like it.

That was EXACTLY what I was going to ask.  It seemed like it could have been just a tad higher.  Thanks for the feedback!
Logged
Pages: 1 [2]
« previous next »