I can say that this method seems to be possible to work with relative ease if you didn't bend the cross bar like crazy getting the thumbscrew out. I had to use a hacksaw to cut off the old sweep arm, so my bar is bent up which made it super challenging to thread into the new receiver for the sweeps. I got it through one side with some good old fashioned cussing, but can only get it partly through the other side. I'll continue to work on that. I think I can make it work, but if it gets too challenging, I'll use the method where you lash the basket assembly to the leg sockets. From what I was doing yesterday, the flexing of the bowl must have caused a porcelain pop which was pretty frustrating. It is great though to have fully functional sweeps in this grill!
Any particular wire you'd use to attach it to the leg sockets?