Received this in the mail earlier this week...
Couldn't find it anywhere but here. Weber and amazon didn't have it
Since I used the 3 mount method for the grates, I couldn't "plug and play" the rack because it's designed to mount on the 4 mounts located on the original WSM
I didn't want to drill MORE holes so I found 4 aluminum pieces that I bent to hang over the pot lip to use as the mounts for the rack.
Needed to ensure these hung at just the right height to allow the rack enough clearance and not prevent the lid from sealing.
Once done, got started on the install.
Hanging rack and pbc grate
Checked clearance of final install. In the pic it looks uneven, but it's very even. Used a level to ensure this
Decided to do dry run last night to see how well I could dial in the vents to get the temps I wanted, see how well it held temps and see how long it went on one load of charcoal.
Got some cool pics of the chimney on and the water pan in
Sunrays...
Smoker eclipse...
Held 215 to 230 degrees pretty well. Initially it ran hot and I had to do allot of "dialing" to bring the temp down and steady. But I got it. load lasted a little over 3 hrs. I think I can go longer if I don't start as hot next time. Used the donut method, maybe I'll do the one Weber recommends? What method should I use?
This test helped me understand what I need to work on and what I wish my JJS had-
Access door
Deeper water pan
Gasket on lid. Saw allot of smoke escape (will get one soon). Which one for the JJ lid?
no door requires me to lift the entire smoking chamber to add more charcoal, wood or water as needed.
I can see myself spilling water from the 3in deep pan during one of the moves.
Been teasing it's first smoke for a while but I promise it'll happen. Even have wood ready
Ribs on Sunday. Hanging method!!
Sent from my iPhone using
Weber Kettle Club mobile app