Hello:
I just recently notice something with my Jumbo Joe. Where the lid rests against the lip of the bowl in the lid holder there are rust marks. I realized that when I place the lid in the holder, the inside of the lid scrapes against the lip of the bowl, UNLESS it's placed carefully in the lid holder. I think that the lid could be designed to be a little more concave, and maybe a little higher than it is, so that there's no way to scrape the inside of the lid against the lip of the bowl. I know the folks at Weber are good about replacing parts, even when a replacement isn't required or requested. I'm not going to ask for a replacement. My questions are -- should I bring this to their attention, or do you think Weber is already aware of this problem? OR is this just a case of your truly being a bit careless in the placement of the lid in the lid holder?