Did a simple mod on my 2013 classic kettle, tired of wearing a glove to control temp...
Also added a gasket this past weekend, amazing how much of an improvement that was!
Nice work, I haven't seen that handle before!
What did you use for the gasket?
Sent from my iPhone using Tapatalk Pro
Quote from: jmike314 on June 04, 2019, 02:24:57 AM
What did you use for the gasket?
Sent from my iPhone using Tapatalk Pro
Got a Lava Lock Kit off of Amazon... Have enough left over for a 26" Kettle whenever I add that to my repertoire...
Quote from: Red_5_Wrangler on June 03, 2019, 11:27:08 PM
Nice work, I haven't seen that handle before!
Took a 1" Oak dowel, flamed it and attached it to a Stainless T door handle from Home Depot... Cook last night it was nice and cool!!!
Did you use the self-adhesive version?
nice handle mod!
I have been wondering if a gasket was worth it. can you tell a bit about what the difference is?
Quote from: Andyinlz on June 04, 2019, 06:28:12 AM
Did you use the self-adhesive version?
I used the self adhesive high heat gasket with the silicone adhesive too
Quote from: kaan on June 04, 2019, 09:31:28 AM
nice handle mod!
I have been wondering if a gasket was worth it. can you tell a bit about what the difference is?
I used to have leaks at multiple points around the lid. After installation ZERO LEAKS! Only out the top vent. I haven't done a long cook yet, but I assume I'll be more efficient. There will be less points for air to get in or heat to escape. Based on the fact that I get thin blue smoke several minutes faster than I used to I think is a good sign...