Here is my attempted repair.
I was missing the rod that the swing out table pivots on.
I had some stainless wire shelves that were in our scrap metal bin at work so I cut myself a section out.
There were smaller size wires attached every few inches so I ground those off except for one.
It can be seen in the top left side of the picture.
This was to keep the rod from working itself out of the bracket over time.
Here it is installed on the left side as intended.
I left the rod long so I could cut it to length.
Here the Z rod is in it's holder.
It then is moved to the hole in the front leg.
And in it's up position.
From the pictures in the manual the pivot rod sticks out about 1/2" and is covered with a plastic cap.
My plan is to cut it a bit shorter than that and use a nickel plated push nut, like those used on the wheel axles.
Now to start sanding and staining.
Anyone know the correct color to stain these?