Weber Table Mods

[Hogsy]

That's a great looking setup!
I love the top shelf

[edhead35]

How is the kettle attached to the table? Strapped down by the handles?

[anderson143]

the handles are just sitting on the wood keeping it from falling threw the hole....I want to get some conduit legs and some shower caps for the ends to get the kettle off the table about a inch so when I use my clamps(during smoking)the table top doesn't get in the way ....I think it would stabilize the grill alittle better putting it back on legs also

[ChadRex]

I got bored and needed a table

Nice table Anderson, I like the added shelf above for rubs & foil. Nice Job!

I would be concerned the weight/stress on the handles would cause wear and tear over time...

[saxart]

This is just a 'hang-on' that I built for my brother.

Jocool-
How is that half-table attached to the kettle?  I really like that set up!

[Jocool]

This is just a 'hang-on' that I built for my brother.

Jocool-
How is that half-table attached to the kettle?  I really like that set up!

They are little metal hooks that I found at the hardware store. I think they are used for hanging pictures and shit.


I'll try and get a picture of the clip nefore I fitted them, and the packaging they came in.

Sent from another planet using Mental Telepathy.

[saxart]

Jocool-
No need for another picture.  That makes complete sense...   What kind of wood is that?   It looks like TEAK?  If so, that table would cost a MINT to make here!

Again, great job!

[Jocool]

That particular one is made of Merbau which is a hardwood used for decking. The big table is made of yellow Balau which won't leech tanines like the Merbau will.

[javahog2002]

I got bored and needed a table

Very nice table.  It would be perfect if that green G was covered by a Blue and Orange Bronco.