Working on a copper SS performer that was used to hold up a tree.

Started by Red_5_Wrangler, October 12, 2018, 10:58:56 AM

Previous topic - Next topic

Red_5_Wrangler

So far so good. I did have to take off a layer of rust so it's a bit thinner but obviously not much. Then used some high heat grease and it fit all but about 1cm. I gave the end of the handle a tap with the rubber mallet and it seems good to go.
ISO - CMist Go Anywhere, the cheif, yellow

jcnaz

A bunch of black kettles
-JC


Bob BQ

BBQ:it's what's for dinner. Grail: 18" Custom - "The Californian"

bladz

You did a wonderful job on the restor.  I like how clean the sweep and crossbar mod worked.  No hose clamps, screws, or rivets needed.  I'll definitely be using that idea.