Looks somewhat similar to that one with some slight design differences. Gauge is probably the same compared to the grill.
Yours, along the bottom has two side wires, a center wire and then two more wires (one between the center and each of the two sides) for a total of 5 wires along the bottom that parallel the longer side of the rectangle. The one my friend has only 4 wires along the bottom (as if your entire center was removed as I've, only partially indicated in the first attached picture).
Yours also has 10 kind of soccer goal shaped portions that are welded to only 2 of the 5 bottom wires. Yours also has a cross brace welded between the two edges of the soccer goal shaped portions.
In contrast, mine has 9 soccer goal shaped portions with no cross sections. However, as indicated in the first picture (just on the front one, but the other 8 are the same) my soccer goal shaped portions also curve at the bottom and are welded to all 4 of the 4 bottom wires and then curves upward (maybe halfway) towards the top.
Additionally, mine has a 10th portion in the front (that I indicated in the second picture because it was easier to show what the back 9 portions looked like using the front portion in the other picture). Basically, instead of having a 10th identical piece, the two center rails along the bottom curve up to make a soccer goal portion that is maybe half the width of the other ones. (see my crummy sketch in grey) That is why I referred to it as a handle.
Thank God I'm not an artist.
Does the rack you are talking about look like this one?
[attachment deleted by admin]