Welcome, Guest

Shop Amazon.com and support the WKC | WKC T-Shirts

Author Topic: Removing the gas assist  (Read 171 times)

bigjeffb

  • WKC Brave
  • Posts: 293
Removing the gas assist
« on: February 19, 2022, 09:00:22 PM »
So I was thinking of swapping the bowl out on a Gen 2 performer but not bothering with the gas assist. However, I don't necessarily want to have a panel and cover for the gas assist that isn't even going to be there. But removing it means looking at the cutouts.
And I wanted to keep the Gen 2 front there because I prefer the look of the stainless panel.
Anybody have any suggestions for repurposing that spot or something to cover it with?

Sent from my LM-V405 using Tapatalk

"I'm not a pit master, and I'm not a chef. I'm just a guy who manages not to burn food."

Red93Lightning

  • Smokey Joe
  • Posts: 14
Re: Removing the gas assist
« Reply #1 on: February 21, 2022, 02:35:22 PM »
Seems like a perfect spot for a temp probe base like a smoke x4.  Put a rectangle of steel so a magnet will stick.