Welcome, Guest
Login or Register

Shop Amazon.com and support the WKC | WKC T-Shirts
« previous next »
Pages: [1]

Author Topic: Touch up paint  (Read 283 times)

DaGoomba

  • WKC Brave
  • Posts: 136
Touch up paint
« on: October 28, 2021, 12:30:21 PM »
Any good suggestions on touch up paint for kettle? Looking to drill hole for probe port (SnS port) and wanted to touch up the drilled edges.

Thanks in advance!
Logged

michaelmilitello

  • WKC Performer
  • Posts: 3821
Re: Touch up paint
« Reply #1 on: October 28, 2021, 07:30:45 PM »
Rust-Oleum 241169A3 High Heat Ultra Spray Paint, 12 Fl Oz (Pack of 3), Black, 3 Count https://www.amazon.com/dp/B08MWY8KTS/ref=cm_sw_r_cp_api_glt_fabc_7K1DVEXZ59YXTTJQNG6X

Use a q tip to apply.  Alternatively, some vegetable oil will work to keep rust away.  I’d do oil personally.


Sent from my iPhone using Tapatalk
Logged

DaGoomba

  • WKC Brave
  • Posts: 136
Re: Touch up paint
« Reply #2 on: October 29, 2021, 03:47:12 PM »
Quote from: michaelmilitello on October 28, 2021, 07:30:45 PM
Rust-Oleum 241169A3 High Heat Ultra Spray Paint, 12 Fl Oz (Pack of 3), Black, 3 Count https://www.amazon.com/dp/B08MWY8KTS/ref=cm_sw_r_cp_api_glt_fabc_7K1DVEXZ59YXTTJQNG6X

Use a q tip to apply.  Alternatively, some vegetable oil will work to keep rust away.  I’d do oil personally.


Sent from my iPhone using Tapatalk

Sounds good… Thanks for the tip!
Logged

Jules V.

  • WKC Ranger
  • Posts: 1641
Re: Touch up paint
« Reply #3 on: October 29, 2021, 05:15:02 PM »
Yeah i would pass on the paint and use oil imstead. Just make sure to get hole as smooth as possible. Deburr and sand it down to a smooth finish. I usually start with 180 grit and finish it with 300 grit.
Logged
Pages: [1]
« previous next »