Fabricated a flavorizor

[HoosierKettle]

Surprisingly easy. This genesis was missing one bar when I bought it. The other porcelain coated bars were sound. My work has scraps of stainless laying around and I had a piece in my garage already. It took maybe 5 minutes with an angle grinder and vise.




Sent from my iPhone using Weber Kettle Club mobile app

[michaelmilitello]

Nice work.   You may have a side business forming.


Sent from my iPhone using Tapatalk

[bamakettles]

There ya go..... and stainless too.  Nice.


Sent from my iPad using Weber Kettle Club

[rudeman]

Sweet!

[Jules V.]

Great job!
How did you bent it?
I wish my workplace allow us to take home or purchase all the surplus stainless sheets/panels/rods that they send out to recycling.

[HoosierKettle]

Great job!
How did you bent it?
I wish my workplace allow us to take home or purchase all the surplus stainless sheets/panels/rods that they send out to recycling.

My boss is laid back and let’s me have various scraps as long as I ask.

I just cut the flat piece and clamped in a bench vise and pushed over the top half sticking out by hand. Then re clamped and repeated the process along the length bending a little at a time until finished. It makes a rounded corner but my original bars were a rounded corner as well.




Sent from my iPhone using Weber Kettle Club mobile app

[Walchit]

Looks good to me

[Tech-Zero]

I heard years ago that the reason Weber didn't use a better grade of SS was because the better grade tended to warp. I will be interested to hear if you see any difference between the factory bars and you home made bar. I am assuming you used a high grade SS for your home made bar. I am presently looking for a better set of flavorizer bars than supplied by Weber.