Welcome, Guest

Shop Amazon.com and support the WKC | WKC T-Shirts

Author Topic: Burner problem?  (Read 563 times)


  • Smokey Joe
  • Posts: 11
Burner problem?
« on: April 11, 2019, 10:03:23 PM »
Hello guys,
I have an 5000 genesis model, i have some problem with firing up, sometimes it get 500 in 10 minutes, sometimes it need 30 minutes and get only 490/480. But the biggest problem is that the heat is not uniform, with all birners hight, only the back one get the grate very hot. If i put 3 piece of bread, the time that back one get burn, the one in front will not even get a good crust.
I havent changed grate/bars/tubes/manifold and, mayne moat important, i used not new gas tank, it was like 60% and now can be lower. What you suggest to change? Or it's normal that the heat is not uniform
Thank you in advice


  • WKC Ranger
  • Posts: 586
Re: Burner problem?
« Reply #1 on: April 12, 2019, 06:47:04 PM »
Have you cleaned the burners. The usually works for me. Use a small wire brush. Up and Down motion on the front and back burners. And a north to south motion on the center burner

Sent from my iPhone using Weber Kettle Club