Author Topic: Solving Da Gasser Code (Read 29690 times)

Golly · « **Reply #60 on:** October 11, 2013, 02:55:28 PM »

base model had no ignigtor or tank scale

note: 1 bowl handle on TBS's redhead

BigRix · « **Reply #61 on:** December 11, 2013, 07:15:46 AM »

I don't know if there was any consensus about the originality of the lid on G$'s gasser, but I bought it from him yesterday and this is what I found.

The handle is most assuredly off set as is the vent.

The difference is about an inch.

The speckled finish on the bowl and lid also match.

jcnaz · « **Reply #62 on:** December 11, 2013, 08:09:06 AM »

Yup!! The lid is definitely NOT a regular kettle lid!

BigRix · « **Reply #63 on:** December 11, 2013, 09:10:10 AM »

Some of the pics in this thread are not showing up.

Were there electric kettles shown that had similar lids?

dazzo · « **Reply #64 on:** December 11, 2013, 01:34:50 PM »

Just a point of reference, I have an older kettle gasser with the lid standoffs (no louvers)...

http://weberkettleclub.com/forums/trading-post/free-gas-kettle-milpitas-ca/msg17357/#msg17357

Something I noticed was that the flame goes out if there is no venting (my lid was received with the standoffs removed - why would someone to that!)

Anyway, I would assume that your vent would need to remain open for the fire to burn.

Just something I noticed, that's all.

My advice, get an original Weber wok and use it as a wok burner - works great

Hogsy · « **Reply #65 on:** September 20, 2014, 03:29:15 PM »

Bump!!
This topic would be handy in the new gas section
Edit:Thanks Troy

Author Topic: Solving Da Gasser Code (Read 29690 times)

Golly

Re: Solving Da Gasser Code

BigRix

Re: Solving Da Gasser Code

jcnaz

Re: Solving Da Gasser Code

BigRix

Re: Solving Da Gasser Code

dazzo

Re: Solving Da Gasser Code

Hogsy

Re: Solving Da Gasser Code