Anyone have a good way to reshape the lid? this is for a 1986 22" kettle. What about adding a gasket seal or something similar around the rim? I would like to be able to use it for low and slow cooks.
If it's out of round, give it a little hug. Rinse and repeat until you're happy with the results after test fitting.
+1 on the hugging of a lid. Definitely helps. Office binder clips work wonders for low and slow cooks. Two on opposite sides as circled below. It will also help shut down/ extinguish coals easier.
(https://uploads.tapatalk-cdn.com/20240701/d2948ec6a402df98190b270650476050.jpg)
Sent from my iPhone using Tapatalk
On gasket I have used Lavalock both high heat silicon pack or just the lavalock self adhesive. Very easy
Sent from my iPhone using Weber Kettle Club (https://siteowners.tapatalk.com/byo/displayAndDownloadByoApp?rid=91018)