Weber Kettle Club Forums

Grill Talk => Weber Mods, Tables and Customs => Topic started by: cubalz on May 03, 2022, 03:40:56 AM

Title: Kettle Steel Handle Removal Process
Post by: cubalz on May 03, 2022, 03:40:56 AM
I am in the process of building a BBQ cart and want to inset a kettle into it on the one side. I bought the stainless steel brackets on line but want to know from someone who has done it before, how to permanently remove the bowl handle so I can mount the brackets?



Thanks!

John
Title: Re: Kettle Steel Handle Removal Process
Post by: Mr.CPHo on May 03, 2022, 05:54:09 AM
I recall @Jules V. removes his bowl handles by drilling out the welds from the inside of the bowl and covering the holes with washers.  You may want to look back through his awesome mods.
Title: Re: Kettle Steel Handle Removal Process
Post by: michaelmilitello on May 03, 2022, 10:37:14 AM
I think a cutoff wheel could work provided it didn't cause too much collateral damage to bowl in the process. 


Sent from my iPhone using Tapatalk
Title: Re: Kettle Steel Handle Removal Process
Post by: bthorn9435 on May 07, 2022, 04:30:51 AM
Cutoff wheel works but you have to be very precise to get it close enough. Problem is one slip and you have
scarred your bowl. Don't ask me how I know this though. The drill and washer route sound interesting will have
to check this out for my next project.
Title: Re: Kettle Steel Handle Removal Process
Post by: cubalz on May 09, 2022, 10:44:48 AM
I think I am going to use the Jules V method. Thanks for everyone's help!!!
Title: Re: Kettle Steel Handle Removal Process
Post by: dwnthehatch on May 10, 2022, 07:24:05 AM
Unless the brackets cover where the handles were, I would just cut the protruding pieces off and leave the welded tabs there. Barely noticeable less potential damage to the bowl.
Title: Re: Kettle Steel Handle Removal Process
Post by: Evochuck on May 13, 2022, 04:09:53 AM
Thats how I did mine
Title: Re: Kettle Steel Handle Removal Process
Post by: andrewshrm on June 06, 2022, 01:21:25 PM
bthorn9435 is right... using a grinder that close to the bowl is scary.  But I was successful the only time I ever tried it.  Didn't have the patience for Dremel cut-off wheeling it.
Title: Re: Kettle Steel Handle Removal Process
Post by: bigjeffb on June 07, 2022, 02:52:25 PM
I used a Dremel cut off wheel just two days ago for this very thing. Took me less than a minute for each side.