Picked up a nice little CL free find today. Have A code 18" but this is the first 22" MBH I'm adding to my collection. Little rough around the edges but still very pretty.
Any resources for replacing 3 vent wheels on bowl? All are missing. Also, last picture shows the bowl is getting eaten through. Any patches I can do here?
Sent from my iPhone using Weber Kettle Club (https://siteowners.tapatalk.com/byo/displayAndDownloadByoApp?rid=91018)
Congratulations on your first 22 mbh. You can buy replacement vents from Weber. There's other sites like grillparts.com, too.
The bowl is a tricky matter. That's rough, unfortunately. The larger holes might be addressed with bolts, nuts and fender washers. I'd avoid placing coal on that side or use baskets. A bit of JB weld on the exterior smaller holes may help. Again avoid coals against it. Perhaps, a black kettle donor to transplant a section of bowl as a patch?
Cellar2full has a thread on fixing some bad damage.
Sent from my iPhone using Tapatalk
I used this to plug some small holes in a beat up black kettle. I taped the holes on the inside and applied the epoxy from the outside. When the epoxy firmed up I pulled the tape.
https://www.acehardware.com/departments/automotive-rv-and-marine/auto-tools-and-maintenance/automotive-adhesives/8164980
Sent from my LM-X420 using Weber Kettle Club mobile app (http://r.tapatalk.com/byo?rid=91018)