Weber Kettle Club Forums
Grill Talk => Weber Mods, Tables and Customs => Topic started by: itskrod00 on April 17, 2019, 10:06:53 AM
-
HAS ANYONE REMOVED THE IGNITER BOX PERMANENTLY AND WHAT DID YOU FILL THE HOLE WITH? AND DID IT AFFECT PERFORMANCE AT ALL?
I WANT TO MOUNT THIS INTO MY BBQ ISLAND, AND WITH THE CURRENT TRIPOD AND IGNITER BOX ITS SUPER AWKWARD TO FIT RIGHT.
-
Shouldn't effect performance whatsoever as long as you cap the hole off. I've yet to see someone do it so I'm not sure what would work best to cap it, but you could easily do it using a bolt, flat washers, and some high temp gasket material.
-
There’s a Summit owners Facebook page. I think they’ll have the answer. I’ve seen this topic there before.
Sent from my iPhone using Tapatalk
-
Just an update I did remove the igniter box. The summit looks slick.
Sent from my iPhone using Weber Kettle Club (https://siteowners.tapatalk.com/byo/displayAndDownloadByoApp?rid=91018)
-
Here it is.
Sent from my iPhone using Weber Kettle Club (https://siteowners.tapatalk.com/byo/displayAndDownloadByoApp?rid=91018)
-
The island is almost finished I will post pic once it’s done and I incorporate the summit
Sent from my iPhone using Weber Kettle Club (https://siteowners.tapatalk.com/byo/displayAndDownloadByoApp?rid=91018)
-
slick for sure!
-
It's good to hear the project is still going. I can't wait to see the finished results.
Sent from my SM-N960U using Weber Kettle Club mobile app (http://r.tapatalk.com/byo?rid=91018)
-
What did you use to plug the hole(s)?
-
What did you use to plug the hole(s)?
Most people use a bolt, washers, and nuts. If you look closely at his pictures that seems to be the case here. I would go further to recommend using stainless steel hardware just to not allow any rust to form.
-
What did you use to plug the hole(s)?
Most people use a bolt, washers, and nuts. If you look closely at his pictures that seems to be the case here. I would go further to recommend using stainless steel hardware just to not allow any rust to form.
Thanks!