News:

SMF - Just Installed!

Main Menu

Probe Port

Started by ClubChapin, May 06, 2020, 05:36:48 PM

Previous topic - Next topic

ClubChapin


I was looking to add a probe port to my CB Roti ring and found these and thought I'd give them a shot.
https://www.amazon.com/gp/product/B01J5QXD4Y/ref=ppx_yo_dt_b_asin_title_o09_s00?ie=UTF8&psc=1


They worked better than expected.  Small enough to fit in the unused motor hole and large enough that a Meater Probe large end or a Thermoworks Pro Series probe will fit through.  The stoppers should work well to plug the hole when not in use.  It was pretty easy to poke a hole through a couple stoppers to slide onto the Thermoworks pit probe and the thicker Meater probe, four mounting a probe in the grommet.

This could be installed in any piece of sheet metal or grill/smoker.

I also put one in a Ball jar lid that we will use for monitoring the milk temp of yogurt we make.


Simple and inexpensive.



2020 05 06 17.15.57" border="0
2020 05 06 17.20.25" border="0
2020 05 06 17.21.41" border="0
2020 05 06 17.25.57" border="0
2020 05 06 17.20.34" border="0
2020 05 06 17.21.48" border="0

JEBIV

pretty cool, you think they will hold up to heat ?
Seeking a Black Sequoia I know I know, I'd settle for just the tabbed no leg grill

ClubChapin

#2
I think so.  I think most silicone is good up to around 500F, which is higher than I usually tend to cook at, especially with my roti.

Good point though, might not want this near your coals or in a searing rig.

Drenno

Depending on the age and quality of the silicone, it will start to melt at 350-400F. You should be okay, best to just suck it and see.

I only really manage to melt silicon when I'm welding on the same piece of metal quite close to the silicone.


Sent from my iPhone using Weber Kettle Club