Vent rivets

[Jocool]

I'm not sure if it has been covered here, but my perfunctory search revealed very little usable information. If I wanted to remove a lid vent for a thorough clean, can I purchase replacement rivets to reattach the vent so it looks factory? They don't offer them for sale through Weber in Australia, and I was wondering if you guys could get them.

Appreciate any help I can get.

[landgraftj]

Don't think you can replace the rivets...may be better off drilling it out and reattaching with a stainless nut and bolt.

[Heyjude]

I did some research a while back. You would need some special tools to make it look factory.
Any rivet experts out there?

[Duke]

I would either go with a stainless buttonhead hex screw or invest in a rivet gun from HD.

[mikeinctown]

When you buy replacement vents from Weber they give you a 1/4-20 bolt and nut.

[Craig]

I would either go with a stainless buttonhead hex screw or invest in a rivet gun from HD.

Is this the transformation tool?