News:

SMF - Just Installed!

Main Menu

Genesis burner screws.

Started by Ceacel, July 28, 2017, 11:51:25 AM

Previous topic - Next topic

Ceacel

Hi.
I've got a red genesis 1000, approx 1998.
The burners need replacing.
Screw heads are rusted to hell.
Any suggestions , tips, or tricks from you wizards of restoration ?
Thank you in advance.
Bob C.

demosthenes9

Depends on which screw heads you are talking about.  If it's the ones inside the firebox at the ends of the burner tubes, you don't want to even try taking them out.  They are fixed in place and are just there for the notches on the ends of the tube to slide under.

The problem is that the spacing fills with gunk.  Spray down with some degreaser and/or try to work a razor in to clean it up.  then pull firmly on the burner tube to remove it.


Ceacel

Thanks a lot.
I've never stripped one of these down before.
I assumed it was a normal screw, but figured I should ask a question before breaking something.

demosthenes9

Quote from: Ceacel on July 28, 2017, 01:45:38 PM
Thanks a lot.
I've never stripped one of these down before.
I assumed it was a normal screw, but figured I should ask a question before breaking something.

you're welcome.  Can't wait to see some pics of it.  Holler if you have any questions.

Wahoo95

Mine were screwed down to the point they had to be removed. I used a screw.l removal tool input ked up from Walmart...I believe it was called a Grabit

Sent from my SM-N910V using Tapatalk